Solar thermodynamic Dinamic 2.0 Idro

The “solar thermal” combines two environmentally friendly technologies:
the heat pump and the solar thermal collector.
Thanks to the physical pattern identical to the one of a normal solar thermal system and to the heat pump components, solar thermodynamic represents the new technology for heating sanitary water (up to 60 ° C), savings up to 85% compared to traditional systems and in an environmentally friendly manner without damaging the environment.

Dinamic2.0 Idro is a system composed of a hydronic heat pump (DHP2.0 Idro) equipped with built-in heat exchanger which is installed together with the solar collector (DCS2.0) systems already equipped with a storage tank for hot water.

Operation

Through the refrigerant that runs in a closed circuit, the fluid enters the solar collector and reacts to the effects of the sun, the rain, the wind, the temperature, etc.

During this process, the fluid warms more simple than in a heat pump.

After this phase, the heat is transferred to a heat exchanger, by a small compressor that heats the water.

The fluid cools down the heat and the circuit is repeated.

Since the cooling fluid boils at about -30 ºC, the system works without sun and even at night, providing hot water at 60 ° C, 24 hours a day, contrary to the traditional solar thermal systems.

Components

  • .

  • The thermodynamic heat pump DHP2.0 Idro

    The hydronic thermodynamic heat pump DHP2.0 Idro, is equipped with built-in heat exchanger it is the soul of the system Dinamic2.0 Idro, It is installed together with a solar collector in systems already equipped with hot water storage tank

    Hydronic thermodynamic DHP2.0 Idro is equipped with a sophisticated electronic control unit from which you can activate all functions.
    Intuitive and easy to use, the display consists of a membrane keyboard and LCD display.

    The hydronic thermodynamic heat pump DHP2.0 Idro is Small and easy to install thanks to the fact that it can be positioned either on the floor or wall.

    Size (mm)

    IWP0279

    *
    Ambient air 25 ° C, humidity 71%, temperature 55 ° C accumulation (EN 255-3)
     
    **
    The measurements are made according to the standard ISO03744.
    The level of sound pressure is measured at 1 meter away from the external surface of the unit outdoors and no channeling.
  • The thermodynamic solar collector DCS2.0

    The thermodynamic solar collector DCS2.0 is made of anodized aluminum with Roll-bond technology.

    Main features:

    • Its weigh is only 8 kg: easy to transport and install
    • No glass, rubber or brittle materials
    • No overheating problems
    • No freezing problems
    • High damp resistance
    • Can be installed on the roof, wall, garden etc.
    • The efficiency does not decrease with dirt
    • Maintenance is virtually nothing and long lived (over 25 years).

    Size (mm)

    IWP0276

Pstudio
Invent Srl
  • Via Alessandro Volta, 54 - 30020 Noventa di Piave - VE - Italy
  • +39.0421 307393
  • p.iva 04096150281 - R.E.A. n. ve-331840 - capitale sociale euro 500.000 interamente versato